StoneRenu

StoneRenu is a clear, water-based coating designed to seal and restore luster on aesthetic stone surfaces. It rejuvenates the high gloss sheen and beauty of stone surfaces that have dulled over time, and costs only a fraction compared to expensive polishing services. It contains low VOC's and may be used on natural silica surfaces such as marble, granite, slate, tile, etc.

StoneRenu provides outstanding resistance towards water, liquids, stains, oil and grease; and protects surfaces from scratching and marring. Due to its outstanding adhesion and durability, it may be applied on indoor and outdoor surfaces horizontally and vertically; on a variety of flooring and countertop surfaces.

StoneRenu is also available in matte finish, and may be stained or pigmented. Please contact us directly for more information. 1 (800) 790-9299.


StoneRenu Coverage | Application | Clean Up | StoneRenu SM Data Sheets




Seal-N-Shine

StoneRenu Coverage

StoneRenuCoverage ranges from 250 to 400 square feet per gallon depending on surface texture and porosity. STONERENU goes on easily and dries to a crystal clear finish. Always test each surface for appearance and penetration before proceeding with application on the entire surface.



StoneRenu Application

StoneRenu may be applied by brush, roller or low pressure airless spray. At 77°F and 50% RH the coating should be dry to the touch in less than 30 minutes. This time may vary based on prevailing conditions. One coat is usually sufficient however if a second coat is desired for greater gloss and/or protection, allow a minimum of 30 to 60 minutes between coats. Prior to application make sure that washed surface is allowed to thoroughly dry. The coated surface can be subjected to light foot traffic after it is fully dry. Allow at least 24 hours time for optimal curing before subjecting the coating to heavy traffic. Do not apply at temperatures below °F or above 90°F. Hold off the application if rain or heavy dew is imminent. Avoid heavy buildup, puddling, and excessive overlapping of sealer.

StoneRenu Clean Up

Clean spills and splatters immediately with soap and warm water. Clean hands and tools immediately after use with soap and warm water. After cleaning, flush spray equipment with mineral spirits to prevent rusting of the equipment. Follow manufacturer's safety recommendations when using mineral sprits.

Product Sheet

  • StoneRenu Product sheet