SealCote AS (Anti-Slip) is an environmentally-friendly, 2-part urethane non slip protective coating that seals and provides a high gloss decorative finish for a variety of hard indoor flooring surfaces including concrete, stone, VCT, terrazzo, marble and tile.

SealCote AS has resistance towards abrasion, stains and water that helps protect the coated surface from wear and damage, reducing frequent costly maintenance such as stripping, polishing and waxing in commercial environments such as grocery stores, retail stores, hospitals and schools.

SealCote AS features a pre-mixed aggregate for commercial floor applications where durability, high gloss and the ability to be cleaned with auto scrubbers is a requirement. SealCote is formulated from cutting edge, non-hazardous polymers that are free of harmful fumes and odors, and is an improvement on the typical wax floor coatings widely used on hard flooring surface.

The surface maintains a beautiful finish and resists marring, staining and discoloration. Floor maintenance is also reduced to a minimum of two - five years before reapplication is required.

Benefits | Application | Technical Data | Data Sheets

SealCote Anti Slip

SealCote Benefits

Anti-Slip - Provides a durable non slip surface that far exceeds ADA and OSHA standards for wet and dry COF. Ease of Cleaning - Can be cleaned with mops, brushes and auto scrubbers in commercial settings. No More Stripping - Stripping, burnishing or waxing are no longer necessary.

When it is time to re-coat, simply add a fresh coat right over the existing coat. Quick and easy, once evey 2 to 5 years. Cheaper - No stipping or burnishing means less floor maintenance labor and lower maintenance costs. An estimated 86% of floor care cost is labor.

SealCote can eliminate 30% to 70% of that cost. Seals Grout - SealCote prevents staining and built-in mildewcides inhibit the growth of mold and mildew which cause discoloration. Anti-microbials may be custom ordered.

More Sustainable - SealCote is a great way to make your facility more "green" compliant. Stripping, burnishing and re-waxing floors emits air pollutants, creates chemical by-products and wastes precious commodities such as electricity and water.

SealCote Application

SealCote AS is a 2-part urethane system which includes the primary emulsion and a catalyst that are mixed together just prior to application at a 4:3 ratio. It can be applied by brush, roller or HVLP sprayer without the need for extensive surface preparation. To ensure lasting adhesion and flawless finish make sure that the target surface is free of dirt and debris.

Special attention should be given to the removal of oil and grease type contaminants as they will prevent SealCote from bonding with the surface. All basic precautions associated with paints and painting should be followed including proper ventilation, masking off areas that will not be coated and preventing air borne debris from invading the area being coated and while the coating is wet.

Ventilation is required when applying SealCote. One coat of SealCote AS is usually sufficient and coverage rates are approximately 550 s/f per 120 oz. kit on smooth flooring surfaces.

SealCote Technical Data

Chemical Data:
NVW (%) = 37.5% (+/- 1%)
pH = 7.5 - 8.5
Visc. (cps) = 1800
Flash Point = > 201°F
Chemical Stability = Stable
Polymerization = Does not occur
Storage = 50 - 80°F

Physical Data:
Koenig hardness = 140